Install Ductless Air Conditioning Systems Where You Never Thought Possible
United CoolAir Corporation will change the way you think about ductless air conditioning once you understand more about this highly versatile MiniCool system. The MiniCool is the first commercial-grade ductless air conditioning system that effectively addresses the concerns of condensing section location and heat removal in commercial applications.
Conventional Ductless Systems Have Limited Commercial Flexibility
Traditional residential-type ductless systems used in commercial installations are limited to an outside condensing section location as well as the distance between evaporator and condensing sections. They also lack the customization needed for effective commercial cooling applications.
The MiniCool Takes Ductless Mini-Splits To a New Level
The MiniCool can be used in high-rise buildings where space for outside condensing section is non-existent. The condensing section is designed for indoor installation with the waste heat ducted to an outside wall or other suitable location. Condensing section location can be in ceiling plenums, storage areas or any out of the way location.

With the MiniCool mini-split system, you get
. . - an internally ducted condensing section
. . - split-able up to 250 feet
. . - one, two or three independent refrigeration circuits
. . - one, two or three tons per circuit
. . - choice of condenser cooling options
. . - 24-volt control system
. . - indoor or outdoor condenser location


Internally Ducted Condensing Section
With the MiniCool, you can overcome architectural constraints, such as a sloped roof, you can still utilize this technology. In historical applications where the exterior of the building must remain "clean" the condensing section can be tucked away in an attic, basement or crawl space. In some areas that are prone to vandalism the condensing section can be placed out of reach as well as out of sight. back to top

Split-able Up To 250 Feet
The MiniCool evaporators can be split a far-reaching 250' in any direction. That's over three times longer than conventional ductless systems. Components can even be located on different levels. The combination long refrigerant run and ducting option provide unlimited flexibility. back to top

One, Two or Three Independent Refrigeration Circuits
The MiniCool condensing section can have from 1 to 3 independent refrigeration circuits allowing separate control of each evaporator location. This allows for different refrigeration options that can be utilized on each circuit such as flooded condenser for winter cooling or hot gas bypass for improved operation. back to top

One, Two or Three Tons Per Circuit
Refrigerant circuits can be sized from 1 ton up to 3 tons of cooling for single, dual or triple circuited systems. Any combination is possible from 1 to a total of 9 tons of cooling. This provides even more flexibility when designing an application with a variety of loading.
back to top

Condensing Section Options
The MiniCool condensing sections are available as air-cooled, water-cooled or heat pump configurations. This choice allows you greater opportunities to match the heat rejection mode to the facility and available resources. back to top

24-Volt Control System
Simple 24 volt controls make the MiniCool system ideal for commercial applications. Each circuit operates from a simple manual thermostat or a programmable controller. Since all circuits work independently, cooling on the remaining circuits will continue to operate if one is interrupted. There is no remote control to loose or need to understand confusing operational handsets. back to top

Indoor or outdoor condenser location
The standard MiniCool indoor, air-cooled condenser can be adapted for outside use through the addition of a factory installed outdoor modification kit for additional installation flexibility. back to top

Click Here for MiniCool Options

Click Here for United CoolAir Web Site

Click Here for Details